15 Sep
2013
15 Sep
'13
10:04 p.m.
At 11:18 AM 9/15/2013, Sander Reiche wrote:
Jerome,
Works like a charm! Thank you very much indeed!
But, I follow DEC-11-UTECA-B-D (PDP-11 TECO User Guide) and the part
on the
ET flag (page 78) doesn't state anything about lower/uppercase. Only
the EU
flag which I didn't get to work at all.
Where did you find this amazing piece of information?
It's in the TECO Pocket Guide - here's the ET bits for TECO-11 (with
zero bits ignored):
Bit Value Initial Value
0 0
2 1 if terminal is a scope
4 1 if terminal has lower case input
128 1 Before TECO's prompt
512 1 If terminal is a VT52 and VT52 Support is available
1024 1 If VT11 is present and VT11 support is available
EU is an output flag - if EU = 0, the terminal cannot display lower
case so TECO flags lower case characters.
If EU = -1, the terminal supports lowercase output.
Another reference is the "Standard TECO" (sic) guide:
<http://h71000.www7.hp.com/doc/73final/documentation/pdf/teco.pdf>http://h71000.www7.hp.com/doc/73final/documentation/pdf/teco.pdf
Section 5.16 describes the ET and EU flags.
73,
-Rick