4 Jan
2002
4 Jan
'02
1:09 p.m.
On Fri, 4 Jan 2002, Doc Shipley wrote:
cable with a (Doc ducks & prepares to rub) 36-pin
Centronics connector,
plus eyelet ground, on one end and a female card-edge connector on the
other. The shrouds are steel, squared, and embossed "TANDY" on both
ends. While I've never seen one, I'm guessing it's a Tandy printer
cable.
That is what was used on the TRS-80 model 1, 3, 4?
If I remember correctly (it's been about 20 years), it was part number
26-1401?
Model 2 and 100 used a dual row header, and of course, the PC clones used
an "RS-232 connector" :-)
Since several of their printers were made by Centronics, even though
Centronics didn't make the connector or cable, this might be about as
close as we can get to a correct usage!