27 Oct
2020
27 Oct
'20
10:14 a.m.
Hi All,
I have an EP-1 eprom programmer from BP Microsystems.
The rubber feet melted. It was in my closet. I have no clue how it got
that hot, or if they
are just some composition for them to melt.
My question is how do I clean this up? Acetone, paint thinner? I scraped
off the feet, so there is
just a few 'streams' of melted rubber down the sides, and a bit that
somehow got inside (also on the side, not on the electronics).
Just looking for some ideas before I start applying chemicals...
Thanks,
Kelly