10 Dec
2002
10 Dec
'02
3:28 a.m.
show scsi shows the KZQSA bit doesn't show any devices under it like
what show dev shows for the RF35 disks on the system.
I'm about to find a LInux box to put the tape on to make sure that its
not the tape drive...
David
On Tuesday, Dec 10, 2002, at 12:14 America/New_York, Kevin Handy wrote:
Zane H. Healy wrote:
> From the its been way too long to remember
department...
>
> I just put an old HP SCSI 9-track tape drive on my 4000/400 running
> Vax/VMS 5.2... Does VMS probe SCSI devices at boot time? Is there a
> way to access this drive without re-generating the system..?
>
SCSI gets probed at boot time. You might try a
"show device" or "show scsi" at the consol prompt
">>>"
to see if it can see it.
What happens when you do a 'SHO DEV MK'?
For example:
$ sho dev mk
Device Device Error Volume Free
Trans
Mnt
Name Status Count Label Blocks
Count
Cnt
MONK$MKA500: Online 0
$
Though the above is a on a PWS 433au running OpenVMS 7.2-1H1 and the
drive
is a DEC TLZ06 (4mm DAT).
Zane
Try this
run sys$system:sysgen
SYSGEN> autoconf all
then do the "sho dev mk" again.