24 Oct
2016
24 Oct
'16
10:37 a.m.
On 10/23/16 2:59 PM, Al Kossow wrote:
On 10/23/16 11:50 AM, shadoooo wrote:
The voltages are based on TTL levels. What are the unique voltages?
The key was limited leakage current and input current to not load the
bus by inserting or removing
current from a node (there is a specified maximum in per node and total
nodes). That cover input
to card devices and bus driver leakage.
Logic low voltage is typical of TTL and the driver device has to sink
that current and meet that value.
Logic High was set by the terminator devices at 3.36V but the threshold
is lower based on the bus
receivers.
By late 1970 it was an easy spec to meet, When first used (pdp8e) it
was new and the ICs
were not so great with leakage current and output device saturation current.
Every time this comes up the world is supposed to stop if not met. The
LSI-11 bus (qbus)
was actually harder as it was 120 ohm terminated and HeathKit did it
with common TTL
and the CPU was DEC standard LSI-11 and it worked out to 18 slot backplanes.
Allison
The problem is that there aren't open drain
bus transceivers, but the
problem could be solved simply using input-only and output-only components,
connecting two in parallel but opposite direction on bidirectional pins.
The reason for using the old parts is the logic thresholds are unique to
the Unibus to handle worst-case bus loading and the termination voltage they
used.