16 Sep
2008
16 Sep
'08
10:41 p.m.
ard at p850ug1.demon.co.uk wrote:
derschjo at msu.edu wrote:
Yep, 8V from U1. (well, 7.92V actually, I assume that's within
acceptable range?)
After looking over the schematics pointed out to
me
(http://oldcomputers.net/Attache_Schematics.pdf -- see pg. 8) I metered
out the voltages at the op-amp and I'm getting 8V (which, if I'm reading
the schematics correctly, is not unexpected). I'm not sure where else
on the board to check (I'm still learning this stuff, but I'm getting
better, honest!).
I get nothing at all at the actual power supply outputs.
This is a relatively unconventional and repairer-friendly SMPSU! The chopper
control circuitry is all on the output side of the isoaltion barrier and
the startup supply comes from a little mains transformer and linear regulator.
Start by checking for the +8V supply from U1 on the PSU mainboard. This, I
suspect is present, it's the 8V you've seen on the op-amp.
Now check for the 5V reference voltage from pin 14 of
U4 (the TL494).
Hmm, I get 6.75V (measuring from Pin 7 (gnd) to 14.)
Now, I think that TL494 should be oscillating, at
least at startup. See if
you get anything on pin 8. A TL494 datasheet would be a useful thing to have!
7.91V on pin 8. (I have a datasheet at
http://yahozna.dyndns.org/scratch/tl494.pdf). I scoped it out, and pin
5 is oscillating, a nice sawtooth.
What voltage do you see on pin 3 (Comp) of this chip?
That's the output of the
error amplifier IIRC. It appears there's an overcurrent shutdown circuit
connected there, maybe that's shutting it down.
0.06V on pin 3.
Main voltage regulation is the comparison of -ER (half
the reference voltage)
and a divided down version of the 5V output on +ER.
What about pin 9? If that's high (8V), it'll shut the supply down. There's a
chopper overcurrent circuit and a +5V overvoltage circuit connected here I
think.
0V on pin 9.
Whatever you do, don't disable any of the
overcurrent or overvoltage circuits
If there really is a problem, doing that can prove spectacular and
expensive!
I won't, not that I have any clue how to do that at this point :).
Thanks again for the help!
Josh
-tony