26 Mar
2018
26 Mar
'18
7:37 p.m.
So, from what I can see, the drive should spin up correctly, but for
some reason it goes into fault mode. I am right in thinking that upon
load, the heads should continue moving forward until the first track is
found, right? I should not have to perform a seek manually from the PDP?
If this is not the case, perhaps there is something else wrong.
I?m not an RL02 hardware expert at all, just a daily user back in the day. I?m reading
this assuming that at all times the drive is correctly hooked up to an RLV12 in a running
PDP with the correct cable and termination present on the drive? If it isn?t you?ll get a
fault condition instead of ready after spin up.
A