16 Feb
2015
16 Feb
'15
5:31 p.m.
On 16/02/2015 20:38, Robert Jarratt wrote:
What other tests would you suggest? I do have a
capacitance meter to check
values. I would have desolder them of course. Would you test just the
electrolytics or all of them? I don't have an insulation tester though. Any
other tests?
Regards
Rob
Check the leakage current using a bench supply (same setup as reforming)
- particularly C321. Leakage here may be causing a DC offset to be
applied to the vertical yoke. If you have no luck here then have a look
at the schematics for the Elston/Digital monitor board in MP00633 or
similar. Expected waveforms are given for some points in the circuit.
Using a scope you may be able to work out where the wobble is coming from.
Matt