7 Jul
2003
7 Jul
'03
9:46 a.m.
Hey Dwight,
If you write something, I'd like to get a copy too. I finally got a
working iuP 201. BTW I've been thinking of making a PC interface for the
UPP 103. I've finally got some docs on it and found out that it only uses
about six commands; three writes, two reads and one read status. I don't
know what they are but it should be too hard to grab the data with a logic
analyzer. I'm not planning on doing it anytime soon, right now I'm busy
re-building some MDSs.
BTRW do you know if there was ever any software written for ISIS to
operate the iUP 201?
Joe
At 10:26 AM 7/7/03 -0700, you wrote:
Hi Tim
If someone else doesn't get you anything, I can write something
for you. I think you can easily drive it from the printer port
with an adapter cable( I've not totaled the signals needed ).
Some of the newer boards require sequencing that I don't have
information on but for cards that program things like 1702A's
or 2708's, I have info on the sequences needed.
Dwight
X-Authentication-Warning: huey.classiccmp.org:
mailnull set sender to
cctalk-admin using -f
>From: "Tim Shaw" <T.Shaw(a)corp.amc.edu.au>
>To: cctalk(a)classiccmp.org
>Subject: iUP-201 PC software
>
>Hi Robert
>I found your request for modules for a iUP201 Universal Programmer.
>I have just dusted off a iUP-201 we have had sitting on a shelf for as long
>as anyone here can remember.
>I cant help you with modules but I would be very grateful if you could help
>me with software to drive it from a PC.
>I need to use it to read the contents of a 2732 EPROM from an engine volume
>generator I hope to update.
>
>regards
>
>Tim Shaw T.Shaw(a)corp.amc.edu.au
>Senior Technical Officer (Elect) +61-3-63354805 Ph
>Technical Services +61-3-63266493 Fax
>Australian Maritime College www.amc.edu.au