25 Apr
2021
25 Apr
'21
4:18 a.m.
I have it fixed with this tube:
https://www.aquatuning.no/vannkjoeling/slanger/tubes/2265/masterkleer-tubin…
Best regards,
Plamen
On Saturday, April 24, 2021, Kurt Nowak via cctalk <cctalk at classiccmp.org>
wrote:
I was going to mention him too but you beat me to it.
He does really great
nice work. I've had a few QIC drive rollers replaced through him.
http://www.terrysrubberrollers.com/
-Kurt
On Fri, Apr 23, 2021, 20:32 Chuck Guzis via cctalk <cctalk at classiccmp.org>
wrote:
On 4/23/21 8:11 PM, Curious Marc via cctalk
wrote:
machined
I tired several methods which worked to some
extent (afore mentioned
silicone tubes, shrink wrap, eBay bought molded rubber
overwraps, grooves and add O-rings), but now I just strip my
capstans clean and coat
them with plasti-dip. Methods in shown my various videos (like here
https://youtu.be/cTZCD4OXETk ). Only plastidip and o-rings have been
durable enough in the long run, and plasti-dip is easier. I have not
done a
capstan this large though. There are also some
folks out there that will
also commercially recoat a capstan with correctly molded and vulcanized
rubber.
Marc
In the past, I've used this guy:
http://www.terrysrubberrollers.com/
Top-notch work.
--Chuck