Looking for RL02 cable and terminator

... like the subject line says. Now that my 8/A is up and running it's time to hook up the RL02. I do have the interface board plugged into the Omnibus, the correct boot ROMs on the option board, and the RL02 has the Unit "0" plug but no cable or terminator. I could make my own if someone can tell me where to get the connectors that fit the drive end. Also, I think someone cannibalized the disk brush out of mine :( There is a big open area towards the right rear of the disk compartment and a pin with a snapring groove protruding downwards, but nothing in the empty hole there except two silver-colored tubes down below (air ducts?)... seemed pretty clean inside, as it should. So I left the heads parked (blocked by the transport plate), inserted the disk pack and ran the blower for a while anyway. Fault light was on, load light was not. I didn't hook it up to the interface board (obviously :) but not being well-acquainted with these drives I don't know if it *has* to be connected before the fault light goes off, or the heads free to load, or both... I do have a copy of the "RL01/02 Disk Subsystem User's Manual" but the service manual and parts list looks essential at this point. Hope it's on bitsavers ;) Thanks for any help. -Charles