6 Sep
2004
6 Sep
'04
6:09 p.m.
Hello (again!).
I'm very pleased with my VAX 4000/300 thus far, but I'm about to get a
KZQSA card from someone, and I need to move my TQK70 controller over on
the Q-bus so that the KZQSA card can fit into the machine. However,
when I did a test run of this, the card was responding (show dev showed
the card), but it wouldn't find the TK70 tape drive attached to the
TQK70. Is there a jumper I have to set? Or did I screw up in some other
way?
Thanks.
Phil.