6 Aug
1999
6 Aug
'99
5:08 p.m.
On Fri, 6 Aug 1999 allisonp(a)world.std.com wrote:
Yep! Seems to be the case, and premised on some further testing it has to
have an ID of 1. Hmmm! I didn't try 0, but it shows all ID positions as
occupied in the T 50 display.
- don
My thought was
that I could use both on the VaxStation and use them to
duplicate some tapes that are save_set(s). Apparently it cannot be done
on the VS. Either unit is recognized when connected alone, but when both
are connected the FA is always recognized as MUA0 and the GA is ignored.
Does anyone have an explanation for this, or am I just doing it wrong?
The drivers for VS2000 are designed assuming a single device on the scsi
bus and only one tape best I know. Either that or the two being different
scsi firmware are interacting in some bad way.