Trying to get running an LSI 11/23

I've been tinkering with this mutt LSI 11/23 system I've got and am trying to get it running. It's a custom-built system that has a mix of DEC and third-party boards. It's configured as follows--my apologies if I'm not conforming to standard DEC notation here [notes in brackets]: Cage 1 Slot 1: DEC M8186 | CAMINTONN 504 [1] Slot 2: Dataram Diceon [2] Slot 3: Data Systems Design A4432-4 | Grant Continuity [3] Slot 4: Emulex TU0110401 [4] Cage 2 Slot 1: Emulex Tu1110406 [5] Slot 2: Grant Continuity | Digital Pathways TCU-50DYR [6] Slot 3: MDB DLV-11J | DEC M9400 [7] Slot 4: Empty [8] Notes: 1. I believe the Camintonn card is memory 2. This has "RK:" written on the handle...an RK05 disk controller? 3. The Data Systems Design card has "DY:" written on the handle. 4. Tape controller; is connected by 25-conductor ribbon cable to adjoining Emulex card. 5. See note 4. 6. A real-time clock 7. The M9400 has "HB BOOT" written on the board. Is this the boot ROM card? 8. Does there need to be a bus terminator here? The DLV-11J is a 4-port serial card. Thanks to those who provided the documentation to get it wired. I think I have it correct. I've jumpered pin 3 to the RxD line and Pin 8 to the TxD line on my RS232 port. I've also jumpered pin 4 to ground as directed. The system powers up. There are +5V and +12V LEDs on the front of the panel that come on, and I've checked these lines at the power supply and they are good. One oddity: the terminal marked -12V is a perfect -0.00 on my volt meter. WTF? Anyway, how can I tell if anything is happening inside this thing? I can hit the BOOT switch and the RUN light goes on. There's a RUN switch with a momentary HALT position and an ENABLE position. I can hit the HALT switch and the RUN light goes off. I put the switch back in the ENABLE position and then hit the BOOT switch and the RUN light goes back on. I see nothing on my terminal (a PC running Procomm Plus in DOS so I have real serial ports instead of the bullshit that Win98 tries to pawn off as serial ports). I eventually want to boot RT-11 off floppies on this system. I guess I'll need a disk controller at some point. I'm completely lame. This is the first DEC system I've seriously tried to get running so I'm starting from -1 here. Any ideas? -- Sellam Ismail Vintage Computer Festival ------------------------------------------------------------------------------ International Man of Intrigue and Danger http://www.vintage.org [ Old computing resources for business || Buy/Sell/Trade Vintage Computers ] [ and academia at www.VintageTech.com || at http://marketplace.vintage.org ]