Need Shugart 851 manual

On Thu, 28 Feb 2002, Joe wrote: Been offline a few days, Joe, so missed a timely response. This should give you a pretty good picture of the jumper settings. - don CUSTOMER CUT/ADD TRACE OPTIONS BRD TRACE SHIPPED FROM FACT. LOC DESIGNATOR DESCRIPTION OPEN SHORT 5E 5E Terminations for Multiplex Inp. Plugged 4F DS1 Drive Select 1 Input Pin Plugged 4F DS2,3,4 Drive Select 2.3.4 Input Pins X 4F 1B,2B,3B,4B Side Select Opt. Using Drv Sel X 3F RR Radial Ready X 3F RI Radial Index & Sector X 4F R (Shunt 4F)* Option Shunt for Ready Output X 3F 2S Two Sided Status Output X 2F 850/851 Sector Option Enable 850 851 4F I (Shunt 4F)* Index Output X 4F S (Shunt 4F)* Sector Output X 3F DC Disk Change Option X 4F HL (Shunt 4F)* Stepper Power From Head Load X 4D DS Stepper Power From Drive Select X 5C WP Inhibit Write When Write Protected X 5C NP Allow Write When Write Protected X 3E D Alternate Input-In Use X 5B M Multi-Media Option Plugged 5C DL Door Lock Latch Option X 4F A,B,X(Shunt 4F)* Radial Head Load X 3E C Alternate Input-Head Load X 4F Z (Shunt 4F)* In Use From Drive Select X 5C Y In Use From Head Load X 5E S1 Side Select Option Using Dir Sel X 5E S2 Standard Side Select Option Plugged 5E S3 Side Select Option Using Drv Sel X 8E TS,FS** Data Sepaation Option Select TS FS Plugged 3E IW Write Current Switch Plugged*** 3C RS Ready Standard Plugged 3C RM Ready Modified X 5C HLL Head Load Latch X 6E IT In Use Terminator Plugged 3E HI Head Load or In Use to In Use Ckt X 8D F**** Remove for MFM encode, Inst M2FM X 7D AF***** Install for FM or MFM encoding Plugged 7D NF***** Install for M2FM encoding X *A 16-pin programmable shunt is **The SA851 offers a standard data provided for the eight most separator as in the SA801, and an commonly used cut track options. optional data separator which These traces are usually shorted properly separates data and clock as shipped from the factory. bits through the soft-sectored IBM The traces can be opened with a standard format and address mark knife blade or small screw driver. area. Trace FS offers the standard separator and Trace TS offers the ****MLC 10 only optional separator. Either may be *****MLC 11 only selected through a shorting plug. ***Write current switch is plugged to the interface. 16 15 14 13 12 11 10 9 | | | | | | | | Shunt F4 > | | | | | | | | Z| HL| A| B| X| I| R| S| 1 2 3 4 5 6 7 8