PS/2 P70 SCS problem

I have a question concerning the IBM OEM version of the FD MCS-700 SCSI-2 card. As most of you have already heard, I've recently gotten my P70 running again under OS/2 Warp Ver. 3 and regardless of the slot it's placed in or the configuration, the MCS-700 seems to be conflicting with the onboard ESDI controller in protected mode. POST is reporting the following numeric error on bootup: 1047000 221 If the SCSI board is left in, OS/2 will run for a while and then start locking up, which makes sense if the conflict is in Protected mode. DOS will run without errors. The ADF was copied and loaded to the Reference disk without a problem. The Reference diskette diagnostics configuration report shows the wrong configuration with the board install and I've not attempted to go any further with the SCSI board installed. With it removed the diagnostics goes all the way through without errors, showing the correct configuration. The only nonstandard thing in the P70 is the Evergreen 'Rev To 486' upgrade using the 486SXL2 processor. It's benching out at over 12,800 dhrystones. The P70 also has the following installed: - 120meg DBA hard disk - 8meg planar RAM - Etherlink III MCA - 387-20 math coprocessor - floppy disk replaced with that from an 8555 (Mitsubishi drive, p/n 72x6068) - OS/2 Warp Ver. 3 with the Evergreen cache enabling software - MS-DOS 6.22 (in daul boot) - MS Windows 3.1 (in Win-OS/2 mode) - Logitech Cordless Mouseman Pro The ROM version on the MCS-700 is 1.01. I've tried it in both slots as well as tried changing the IRQ and such in the Reference disk setup. All of this had no effect on the error. Any suggestions anyone might be able to make would be greatly appreciated. Thanks and take care. Jeff -- Collector of Classic Microcomputers and Video Game Systems: Home of the TRS-80 Model 2000 FAQ File http://www.geocities.com/siliconvalley/lakes/6757