28 Dec
2013
28 Dec
'13
7:06 a.m.
On 12/27/2013 10:50 PM, Cory Smelosky wrote:
On Fri, 27 Dec 2013, Josh Dersch wrote:
Well, it's a pain to enter manually, but you can find a TU58 bootstrap
here: http://www.pdp-11.nl/ba11-boxes/ba11va/ba11va-info.html
It's a couple dozen instructions, but once you've punched it in a few
dozen times it'll be like instinct :).
On 12/27/2013 8:46 PM, Cory Smelosky wrote:
11/23 with a 1M memory board. Which should be >128K so long as
nothing
went wrong.
I have a DLV11-J...I THINK one of those can be used as a TU58...but I
don't have a bootstrap module (yet) so I'm stuck with ODT. Evening...
I'm fighting with trying to get my disk formatted so I can use my PDP-11s.
;)
Tape records are:
0 zrqch0
1 zrqah0
2 zrqch0
3 zrqah0
Opening port /dev/ttyUSB0 .... Port open
?
Opened zrqch0 read-write
rrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrr
And it stalls after that many R and goes no further. I have no
alternative means to boot XXDP on this system...my only option is vtserver
until I get a drive formatted.
What hardware do you have in the -11 system? I seem to recall that vtserver
requires 128K to function properly. (Also -- I don't suppose you have a
second SLU, which would allow booting from emulated TU58...) What baud rate
are you running this at? I've had a bit of trouble here and there with USB
serial ports, you might try a different baud rate, start with something
slow...
I'm running at 4800 baud and I can go no higher or lower due to the lack
of wirewrap tools.
I had ot loading executables earlier...but then it stopped working. I'll
let it sit overnight and pick it back up tomorrow.
Hmm. Very strange, hope things work better tomorrow :). Best of luck!
- Josh
> - Josh
>
>