M9301-YB Bootstrap/Terminator ROM dumps / listings?

So I decided, just for grins (this may be duplicative of what's on a fiche somewhere) to complete the disassembly, and there was something that was puzzling me. There a bunch of entry points (for auto-booting from different devices) which all are of the form: BR foo where foo is the same location. The code doesn't save anything before the branch, it just does it right off. So how does it know, when it gets there, which entry point was used? Well, it turns out that the answer, I am pretty sure, is that with the M9312, location 773024 is even more magic than it first appears. (Slight digression, for those who didn't get the reference: the way the M9312 forces the 11/04 or /34 CPU into the ROM, on power-fail or manual restart, is that when the CPU tries to fetch the PC/PS pair from location 024 - the power-fail/restart vector - the card jams the high UNIBUS address lines to 773000 for two bus cycles, directing the fetch of the new PC/PS to locations 773024-6. Next, when the CPU fetches the contents of location 773024, the basic contents of that location, in the ROM - 173000 - are or'd with switch S1-3 (bit 8, 4xx) through S1-10 (bit 1, 2). So that's how the code jumps to different entry points, based on the contents of S1.) However, from reading the code (yet to verify this on prints, but it _has_ to work this way, the code doesn't make any sense otherwise), it appears that _any_ reference to location 773024, at _any time_, produces the contents of ROM location 773024 or'd with the contents of switch S1!! In other words, location 773024 is effectively a hacky register that allows S1 to be read. (And the M9312 Maint Manual does _not_ make this clear. It talks about how the contents are modified during the power-on PC/PS fetch cycle, but _not_ about the later references part.) Very clever, though! Noel PS: Josh, from what I've seen so far, the code tends to loop on error, not halt. So if your machine's halting...