8 Nov
2005
8 Nov
'05
12:57 p.m.
I think I would check C3001, in case it's shutting
the PSU down before
it's properly started. Then look at the collectors of Q3002 to see if the
thing is detecting an overvoltage.
The under voltage protection is always active :(
When power is applied, the collector of Q3001 goes high (about 4.5V)
immediatly, after about 0.5 seconds, the SCR is fired and the power supply
enter in protection mode.
During the short time of outputs presents, I have check the value (with
scope, multimeter in not enough fast) but they are of the correct value (+5,
+12, -5, -12) but I ignore the tolerance of the under voltage protection.
Maybe IC3001 or IC3002 defective ?
Thanks a lot !
Alberto
------------------------------------------------------
Alberto Rubinelli Mail : alberto at a2sistemi.it
A2 SISTEMI Web : www.a2sistemi.it
Via Costantino Perazzi 22 Tel 0321 640149
28100 NOVARA (NO) - ITALY Fax 0321 391769
Il mio museo di vecchi computers/My old computers museum
http://www.retrocomputing.net
ICQ : 49872318 Skype : albertorubinelli
------------------------------------------------------