17 Nov
2014
17 Nov
'14
8:52 p.m.
Thanks! I'll pull the jumper from W4 and leave the rest the way it is. I
believe with that it will be under software control.
On Mon, Nov 17, 2014 at 2:47 PM, Glen Slick <glen.slick at gmail.com> wrote:
On Nov 17, 2014 12:38 PM, "Ben Sinclair"
<bensinc at gmail.com> wrote:
--
Ben Sinclair
ben at bensinclair.com
Now I'm confused again! If I setup the BDV11 to control the LTC
interrupt,
should I have W4 in or out?
Yeah, I think I was confused about that. I think you would normally have
the BDV11 configured so that the BEVENT bus signal is under software
control so that you don't need to use the front panel Aux switch to disable
BEVENT. But you would normally always have W4 removed on the M8186 so that
interrupts occur when BEVENT is enabled on the bus. The exception would be
if you had something like an M8016 KPV11 which generates its own LTC
interrupts.