tony duell wrote:
[Vacuum cleaner power ratings]
Hmm... may be that one isn't that dump.
In the german
mikrocontroller.net forum it was discussed sometimes ago that
manufacturers of vacuum cleaners really put Heater resistors into theyr
products to rise the pulled power..
I can believe that. Like the extra transistors not connected to anything in some
early transistor radios so the manufacturers could claim 12 transistors or whatever.
Don't get me wron, but I can't see any
need for consumer vacuum cleanersi
above 1600 Watts..what would you do? Suck in the entire carpet and shredder
it?
Nor can I, but I dislike stupid regulations even more.
Exactly as I'm. But in this case I'm not that excitedly..
No, instead your table lamp is protected by a 15A breaker in the
distibution panel. Hmm.. I am told that in some continental
European countries it's common to have a pair of 16 A (230V)
outlets protected by a single 32A breaker. And no other protective
device. So a table lamp is effectively fused at 32A. No thanks.
No. That's hearsay and forbidden everywhere.
I've not seen all the electical regulations for all EU countries... Until I do I will
not be convinced that such
wiring doesn't exist anywere..
Even at EU countries this is unlikely, possibly something like that exists
in the ex-EU Area.
What is the typical German wiring ? A 16A breaker for each outlet?
-tony
No, mostly two or three outlets per room at one 16A breaker, Light is a
separate circuit in most cases.
The Breakers are mostly B16 Type, really fast characteristics. You are
unable to get a welder working with them. 5 running computers are also
impossible b'cause of the in rush current after a short outage (seldom, but
they happen). You have to use C16 or K16 Breakters for that. No Problem
with older wire-type fuses (?) with edison sockets.
Regards,
Holm
--
Technik Service u. Handel Tiffe,
www.tsht.de, Holm Tiffe,
Freiberger Stra?e 42, 09600 Obersch?na, USt-Id: DE253710583
www.tsht.de, info at tsht.de, Fax +49 3731 74200, Mobil: 0172 8790 741