Data General Nova 3 and 6045 Drive Questions

Disk testing update: I have the controller in slot 11 still, and the drive interface cable is connected to the edge paddle that appears to be wire-wrapped to slot 11. I haven't tried it in slot 10 using edge connector P4 yet, because I think I might need to fiddle with the two blue wires (bus grant? interrupt?) I see patched between the slots to do that, and I haven't studied what they do yet. Pictures of the backplane can be found on my blog: http://www.nf6x.net/2016/06/data-general-nova-3-backplane/ Bootstrap from the drive channel still doesn't seem to work. The bootstrap loader does appear to be loaded into RAM, and the loader remains looping at 000377, which never gets overwritten with a word from the drive channel. Reading the drive status register always returns 0 so far. But, I do seem to be talking to the drive, because I think I can make it seek! I cobbled together the following program and assembled it with Toby Thain's assembler found here: http://www.telegraphics.com.au/sw/info/dpa.html 02 .TITL dsktst1 03 .LOC 0 05 00000 062477 START: IORST ; Reset I/O channels 06 00001 060633 DIAC 0, DKP ; Drive status register to AC0 07 00002 065433 DIB 1, DKP ; Drive mem addr register to AC1 08 00003 072433 DIC 2, DKP ; Drive disk addr register to AC2 09 00004 034010 LDA 3, SEEK ; Load seek command to AC3 10 00005 075133 DOAS 3, DKP ; Do seek 11 00006 074433 POLL: DIA 3, DKP ; Poll drive status to AC3... 12 00007 000006 JMP POLL ; ...forever 14 00010 003220 SEEK: 003220 ; Seek cyl 620(8): 15 ; 0 0000 1 10 10010000 16 ; -> 0 000 011 010 010 000 17 .END START This resets the I/O channel, reads the three drive registers into AC0-AC2, issues a near full seek command, then repeatedly polls the drive status register into AC0. I think. Running the program after a fresh drive load->ready sequence causes the drive to emit an audible clunk, so I believe that it is performing the seek! However, stopping the program and examining the accumulators shows that they all contain 0. Incidentally, I see that the assembler I used assembles IORST as 062477, thus clearing the start and done flags. However, other sample programs I have seen show IORST as 062677, which issues a pulse instead of clearing start/done. I did not observe any difference in behavior in my test program when I tried both IORST varieties. Can any Nova experts chime in on any hidden gotchas that might lurk around this? So, back to the task at hand: It seems that the CPU can talk to the drive, but maybe the drive can't talk back to the CPU? I think I'll work on bringing up a memory test next before I look at the hard drive some more. BTW, the console is running at 4800 baud, while I expected it to be at 9600 baud based on the strapping. That needs some more investigation, too. -- Mark J. Blair, NF6X <nf6x at nf6x.net> http://www.nf6x.net/