27 Jun
2016
27 Jun
'16
12:02 p.m.
----- Original Message -----
From: "Brent Hilpert" <hilpert at cs.ubc.ca>
To: "General Discussion: On-Topic and Off-Topic Posts" <cctalk at
classiccmp.org>
Sent: Sunday, June 26, 2016 11:11 PM
Subject: Re: Power cable identification
On 2016-Jun-26, at 1:47 PM, Mike Stein wrote:
----- Original Message -----
From: "Brent Hilpert" <hilpert at cs.ubc.ca>
...
Is it a Cromemco? Inexplicable is right. The Cromemco Z2 S100 chassis from 1978 used
them, I don't know what they were thinking using it that late, unless they got a deal
on a mass clearout.
============
Are you sure it was a Cromemco Z2? If so, it must have been a really old one; I've
seen quite a few Z2s in my time and they all had/have modern IEC type line cord
connectors.
Yup, this:
http://www.cs.ubc.ca/~hilpert/tmp/CromemcoZ2A.jpg
IC date codes on boards were 77 to 78.
Presumably bought as a package as it had Cromemco ZPU, TUART, 4FDC & 16KZ boards.
I replaced the 163 connector with an IEC.
As a matter of fact here's an example with the 163 connector:
http://maben.homeip.net/static/s100/cromemco/photos/cromemco%20z2/Cromemco%…
===============================================================
Yup, indeed definitely a 163 in Marcus' picture; my time selling and supporting
Cromemcos starts in 1980 and by then all models including the Z2 had IEC connectors.
As a matter of fact, from the copyright notice it looks like the Z2 rear panel and P/S
were changed in 1979:
https://goo.gl/photos/LmdwwKb6uPcpWzuf7
m
