Unusual rt-11 msg

An imaged rl02 containing rt-11 5.7 distribution disk generated a bit of an odd message after booting in in simh (v3.81). It came with the following output : sim> att rl0 rt11_V5.7.dsk sim> boot rl0 RT-11FB V05.07 .TYPE V5USER.TXT RT-11 V5.7 Installation of RT-11 Version 5.7 is complete and you are now running RT-11 from your system volume. Your system volume is your working volume if you have used the Automatic Installation (AI) procedure. If you have installed RT-11 using that procedure, Mentec recommends you verify the correct operation of your system's software using the VERIFY verification procedure. You can only perform VERIFY on the valid target (output) media you used for the AI procedure. Run VERIFY before you run CONFIG. To run VERIFY, enter the command: IND VERIFY You should read the file V5NOTE.TXT, which you can TYPE or PRINT. Also, read the Introduction to RT-11, and the Installation Guide which contain much of the information you need to use RT-11 Version 5.7. .R MSCPCK ?MSCPCK-I-MU0-TK50 FW Rev Level is 005/HW Rev Level is 001 ?MSCPCK-W-TUK50 controller below FW Rev 4/HW Rev 2 . ======= Anybody have a suggestion about the last 2 error messages? and can it be easily fixed in the simh code? Ed