1 Mar
2015
1 Mar
'15
7:20 p.m.
Indeed, pin 4 (Vcc1) should be +24V, this is for the motor windings drive.
You need to look at pin 19 (Vcc2) of the LB1620 or the voltage across zener D102.
Follow the pcb trace from the junction of R112 and D102, goes to pin 19, looks like pins 9
& 2 as well, and on to supply the other ICs.
On 2015-Mar-01, at 1:38 PM, Enrico Lazzerini wrote:
Mhmhm... i checked the pcb. The LB1620 pin 4 is wired to the pin on which I
think comes +24vdc... so... let me check what could happens before. Could
happens that is it broken something and it goes to this little pcb +24vdc
instead of 12-15vdc???
I misured the voltage coming to this pcb and over there is +24VDC
This explain well the why this pcb smoke and it is hot.
Enrico
-----Messaggio originale-----
Da: cctech [mailto:cctech-bounces at classiccmp.org] Per conto di Brent Hilpert
Inviato: domenica 1 marzo 2015 22:08
A: General Discussion: On-Topic Posts
Oggetto: Re: How to save two Mitsubishi M2896 drive (spindle motor smoked!)
On 2015-Mar-01, at 9:56 AM, Enrico Lazzerini wrote:
Thanks Tony for your suggestions. What I means
is:
It happen in two distinct times every time when I used the drive to read
through a PC with the software IMD to create images of floppy disks 8 ".
Not
having the correct power connectors i power the
drives in this way: + 5vdc
and ground coming by a PC power supply and +24vdc and ground from a
Chinese
power supply. I must have certainly reversed this
last one even for a few
seconds exchange +24vdc with the ground. Now both spindle motor supplied
also with only +24vdc start smoking in the vicinity of the chip LB1620 and
cause of cooling you can not touch it as hot it is. If I try to measure
the
resistance between pins +24vdc and ground of
each spindle motor drive i
get
1327ohm on FD0 while i measure 19ohm on the
spindle motor drive FD1. There
are no visible damage nor to the components nor the PCB wires.
In both pcbs anyway the chips LB1620 sunburnt from not being able to keep
a
finger on it.
I searched on ebay and the only place that has LB1620 seems to be:
http://www.ebay.it/itm/LB1620-INTEGRATED-CIRCUIT-IC-BOX-74-/390955452872?pt=
LH_DefaultDomain_0&hash=item5b06c2c9c8
The input's pins of the pcb are : +24vdc, ground, and the rest could be a
control.
The point is that I have no experience on these components.
Replace the chip could make it burn again for my inexperience.
I notice in one of the photos you have written 15V for the zener D102, and
on both boards they look like they have been replaced.
D102 and R112 are a simple regulator to reduce the +24V down for the chip
supplies (looking at the photos to trace the circuit).
+24 is otherwise used directly only for the motor windings, in part via Vcc1
on the LB1620.
The LB1620 datasheet specifies the Vcc2 range for the 1620 to be only 8.5 to
14V, not 15V.
Check the Vcc2/zener level to see whether the zeners are good and what
voltage they are.
I expect Vcc2 (and the zener V) is supposed to be 12V or 9V.