26 Sep
2004
26 Sep
'04
7:27 p.m.
[snip]
Most (all?) Cat5 baluns use pins 4 & 5 for this
run -- making sure
that
pair is part of a twisted pair will help a *lot*.
Good news: You could even make an Ethernet/Twinax single jack, if
you're
not running faster than 100Mbps ethernet, as they run 1/2 & 3/6 for
their
pairs -- just use 4/5 for twinax.
[snip]
thanks roger! I think I will run twinax separately from ethernet. I'll
stop by my fav electronics dealer for some connectors tonight...
Amazingly, that's one of the (if not *the*) most
damaging commands to
the
system... and it's the *first* one you read about in the IBM
manuals...
(well, the ones I read, anyway)!
uff. I don't have any manuals :( I was just looking around at IBM'S
website and was googling around a bit but had nearly no luck. No hints
on bitsavers too.
I home someone could provide some links to (at least) basic info.
But before I that I think I have to determine the correct machine type,
right? How can I do this?
Regards,
Wolfgang Eichberger
=====
====================================================
Ing. Wolfgang Eichberger cell.: +43-664-240-65-92
http://www.eichberger.org
email: wolfgang(a)eichberger.org
----------------------------------------------------
Gruentalerstr. 24 - 4020 Linz ? AUSTRIA
====================================================
___________________________________________________________
Gesendet von Yahoo! Mail - Jetzt mit 100MB Speicher kostenlos - Hier anmelden:
http://mail.yahoo.de