4 Dec
2004
4 Dec
'04
10:15 p.m.
On Dec 5 2004, 6:55, Ethan Dicks wrote:
I guess this picture...
http://www.zen22142.zen.co.uk/Prac/vero_circ/8.jpg
... really shows the divot one gets from the real tool.
Yup, that's typical.
The tool looks handy for more than a few cuts, though.
I wouldn't
want to try just holding a bit bare-handed - lots of hand cramps and
slips probably.
Exactly. Given the cost of the genuine tool, I use a pin vice (of
which I have several) to hold the drill bit.
However, if I want it to look neater (I meant to mention this in my
previous message) -- though goodness knows who would care -- I have
been known to use a scalpel or craft knife to cut the copper either
side of a hole and then lift off the small redundant piece. I've also
done that between holes, when I wanted to use two adjacent holes but
isolated from each other.
--
Pete Peter Turnbull
Network Manager
University of York