23 Oct
2013
23 Oct
'13
11:40 p.m.
On Thu, Oct 24, 2013 at 4:35 PM, supervinx <supervinx at libero.it> wrote:
oops, my mistake, sorry about that, you are quite correct 68-pin is needed.
I referenced the wrong cable, it seems I have two cables, see this
picture, the cable is the one to the right:
http://i.imgur.com/E9gFXvl.jpg
P/N is 52G0174
and looking at my notes, you are also correct the SCSI ID should be
set to #1 for external tape. I used no-additional-terminator either.
Also in my notes it seems the tape appeared as TAP02 too (TAP01 was in
the list but not detected).
IBM P/N:
32G0397
Hmmm, but this one has a SCSI2 (50pin) connector, while my P03 has a
SCSI3 (SCSI68) connector on the back...
Did you add a SCSI50 to SCSI68 adapter or your P03 has a different
connector on the back?
I own a similar cable, but it has a VHDC connector, it's for a PS2 95,
but the termination it's the same... can't forget that ugly brick ;) 