16 Sep
2002
16 Sep
'02
7:10 p.m.
On Sep 16, 22:15, Jerome H. Fine wrote:
I understand your answer. Under normal situations
(when MACRO-11
source is translated and the actual code is placed into an OBJ file which
is then LINKed), both ways are acceptable. BUT, Patrick was setting up
the program via ODT (see line four). If Patrick did not realize what the
'
character in the string 177566' meant, perhaps he
just put 177566 instead
so that the three word instruction became:
001000 Mov #110,XBUF 012767 000110 177566
which, of course, is NOT what Patrick intended. However
001000 MovB #110,@#XBUF 112737 000110 177566
is correct and does the job.
So it is not that the first method is incorrect, but for some it might be
confusing.
Hmm. I'd argue that it *is* incorrect, or at the very least, bad practice.
Relative addresses are meant for situations where the target is a label,
indicating something which must move if the code does, like the target of a
JSR, or a block of data attached to the code; if you mean to indicate
something like a memory-mapped register, which has an absolute and
invariant address, you should use absolute addressing.
Given that Pat said he was going to enter the code using ODT, I imagine he
expected the MACRO output to be the correct numbers to enter. But he used
the wrong addressing mode to do that :-)
My personal opinion is that the MACRO-11 program
should make the
situation plain, but unfortunately I suspect that MACRO-11 will never
be modified by the present owners.
I suspect you're right :-) Besides, the output is meant for the linker,
not ODT, and I'm not sure how you could make it really plain that the
numerical value in the output is not what the linker will turn it into,
without a lot of (usually) unneccessary clutter.
--
Pete Peter Turnbull
Network Manager
University of York