Great, my VT52 is shot.

Hello Chris! Sorry that your trusty VT52 failed. But it shouldn't be too hard to repair it! I have successfully restored a VT52 (actually a VT50 with a brain transplant): http://www.datormuseum.se/home/dec-vt5x. My experience is that the capacitors were in good shape. Especially the bigger filter capacitor. I think that DEC used great quality capacitors. It is always a good idea to check the voltages so that they are within the spec. But it should not be necessary to replace all the capacitors in my opinion. The VT52 is a quite interesting design with a very simplistic CPU built from TTL components and a microprogram that has 1024 by 8 bits. Most of the operations inside it is controlled from this program. In mine the sockets for the mikroprogram were bad which meant that it failed to do anything. Then I had a couple of gates that were bad. Den tors 16 apr. 2020 kl 23:07 skrev Chris Zach via cctalk <cctalk at classiccmp.org <mailto:cctalk at classiccmp.org>>: Wonderful: A few weeks ago I forgot to turn off my VT52 and left it running for a day or two. Now the screen is filled with snow and it looks like the text is all over the place horozontally. It would be great to have a picture since it could give some hints on what is wrong with it. My understanding is that the scan is working both horizontally and vertically. Otherwise you would only have a straight line. Unlike many common CRTs this CRT circuitry has no oscillator in it that creates a picture without input. And since the horisontal deflection circuit also creates the high voltage there would be no picture at all unless the horisontal signal is there. This means that the two control boards in the bottom creates some kind of horisontal and vertical signals. These signals comes from a simple divider chain. There could be some kind of problem in the divider chain. But then it would be more likely to not work at all if one of the counters are bad. But it is a good idea to check the H and V signal som they are inline with the spec. Around 15kHz and 60 or 50 Hz respectively. Since I haven't seen how the output looks like I speculating a bit. It could be the case that the divider chain is correct but the video signal is not generated in sync with the divider chain. Then the characters would end up all over the place on screen. There is a flip-flip, made out of a 7400 (E16) and 74H10 (E14) that is the video flip-flop. It controls when the screen is rendered. It might be the case it could cause your problem. I think it is a good idea to check the signals around this flip-flop. I am always a bit skeptical towards 74Hxx. My impression is that they fail more often than standard 74xx. When I repaired my VT52 I made a quick circuit that created a composite video signal from the control board. The signal was fed into a standard CRT monitor which I had around. I could then run the control boards flat on the bench to take measurements rather than assembling prior to each test. I thought that it was quite handy. Any tips or thoughts on where to start looking to fix? The keyboard seems to be working as does the RS232 input (the snow on the screen changes when the pdp11 talks to it) This indicate that since you are using RS232 you have at least some kind of voltage level on +12 V and -12 V since otherwise there would be no communication. And +5V is probably not that bad either. Since not much would operate in that case. Likewise the -5V is probably ok since the char rom would not work very well without the bias. Good luck with your repair! /Mattis Thanks! Chris