26 Jun
2016
26 Jun
'16
3:32 p.m.
These settings work for a DL-11 M7800
9600b console serial port.
Real Time option
540677
5008775B
c29 open/out (not 110 baud)
c31 open/out (not 100 baud)
NP-U out (=no parity/disabled)
2SB-U out (2 Stop Bits)
2SB-U out (2 SB)
EPS out (EPS=even parity when NP is jumrd)
NB1/NB2 these two are set together
both open = 8 databits.
receive crystal 4 o'clock / pos 8
xmit crystal 4 o'clock / pos 8
4608 khz
9600 baud
vector address jumper
V V7 V6 V5 V4 V3 N
0 0 0 1 1 0 1
address jumpers
A3 A4 A5 A6 A7 A8 A9
1 0 0 0 1 0 0
J1 J2 J3
1 0 1
On Sun, Jun 26, 2016 at 5:58 PM, william degnan <billdegnan at gmail.com>
wrote:
On Sun, Jun 26, 2016 at 5:48 PM, Noel Chiappa <jnc at mercury.lcs.mit.edu>
wrote:
My issue (M9312) has been that I can't get XXDP output to the screen, but
I can run the CONSOLE and initiate comms to and from the computer using
CONSOLE. When I run a XXDP routine I don't see anything to the screen so
far, regardless of what switch setting I am using.
Specifically
http://bitsavers.trailing-edge.com/pdf/dec/pdp11/xxdp/diag_listings/1140_45…
CQKC Test
Pages 18 - 61 and beyond provide switch registers and code to follow.
b
--
@ BillDeg:
Web: vintagecomputer.net
Twitter: @billdeg <https://twitter.com/billdeg>
Youtube: @billdeg <https://www.youtube.com/user/billdeg>
Unauthorized Bio <http://www.vintagecomputer.net/readme.cfm>
From:
Fritz Mueller
So far I haven't seen any place in PDP11GUI
to set anything other
than
port and baud rate
You might have to use native OS tools to do that. On Unix, that will be
'stty'; on Windows, you'd have to use native Windows tools to do that; if
you
go to the Device Manager, select your serial port, and click on
'Properties',
it has a tab ('Port Settings') for that (or, should I say, it used to -
not
sure about the most recent versions, they're making it all smart-phone
like
for brain-dead lusers).