12 Jun
2011
12 Jun
'11
6:58 a.m.
Hi,
On 12 June 2011 21:44, Adrian Graham <witchy at binarydinosaurs.co.uk> wrote:
On 12/06/2011 11:40, "Simon Fryer"
<fryers at gmail.com> wrote:
Ahhh. The incantation. Many thanks.
I was hoping that I didn't require a VMS box. Putting together a box
to run VMS is on my todo list. Just not in the short term future. I
guess I should get the aphas powered up to see if the same thing can
be done with Tru64 or if it is only something supported by VMS.
So, first question. Does anyone know how to do a
factory reset on
these. The operating manual isn't much help. :(
For a proper factory reset you need a running VMS host with DECnet
(hopefully phaseIV) started, then you can hop onto it using
MC NCP CONN VIA (ethernet interface) PHYS xx-xx-xx-xx-xx-xx (MAC address
printed on the label on the front)
Then
SET
S(erver)
F(actory)
Y(es)
(from memory :)) The reason you might not be getting output on the VT
is because you can
dedicate each port to a particular LAT session which is why you're seeing
requests for a service name.
Or that the terminal lines are configured off.
Many thanks. I have somewhere to start from now.
Simon
--
------------------------------------------------------------------------
"Well, an engineer is not concerned with the truth; that is left to
philosophers and theologians: the prime concern of an engineer is
the utility of the final product."
Lectures on the Electrical Properties of Materials, L.Solymar, D.Walsh