10 Nov
2018
10 Nov
'18
11:41 p.m.
On 11/10/18 11:00 PM, Tony Duell wrote:
On Sun, Nov 11, 2018 at 6:56 AM Alan Perry <aperry
at snowmoose.com> wrote:
Nice.
It is clean on the inside. A very thin coating of dust.
As far as the hardware itself ...
There is nothing in the left-side drive bay, just the dual floppy drive
in the right-side bay.
There is a memory expansion board (how can one determine its size?) and
the board that the floppy drive connects to (is it all floppy controller?).
That's it.
Is there anything that I should check on it before I connect it to power?
alan
On 11/10/18 10:51 PM, Tony Duell wrote:
There's a catch on each side under the 'step'. Release those
and the
cover comes off. Unplug the drive and power cables from the main
PCB assembly (at the rear right), undo the thumbscrews on the back
and the PCB assembly slides out. On Sun, Nov 11, 2018 at 6:47 AM Alan Perry via
cctalk
<cctalk at classiccmp.org> wrote:
Right now I am looking up how to open up the system unit and
see what's
inside. What I got was the system unit, a VR201 monitor,
a keyboard, a vertical
deskside stand for the system unit, and a LQP02 daisy wheel printer. I
also got the MS-DOS and CP/M doc and software slip cover boxes. The CP/M
disk box is still sealed and the CP/M docs are still in shrink wrap. The
specific need that the seller bought it for involved MS-DOS, not CP/M.
Does it
have any of the optional expansion boards (hard disk controller,
RAM, graphics) in it?
-tony