19 Jan
2003
19 Jan
'03
12:07 a.m.
On Sun, 19 Jan 2003, J.C.Wren wrote:
Since this is a single sided board, as far as
components go, the
I assume you mean single layer?
bottom side would be easy. Scan it. The top side would
be harder, but
given that the majority of the parts are .3" wide, with the schematic, a
lot of the routing can be inferred. And while I haven't looked closely
at an Apple I board, the trace widths should be pretty wide, by todays
standards. So by doing an overlay, and perhaps using some bright lights
for manual verification, it seems that very near replica could be made.
Check out these photos:
http://vintage.org/special/apple-1/apple-1-front.jpg
http://vintage.org/special/apple-1/apple-1-rear.jpg
