28 Oct
1999
28 Oct
'99
8:08 a.m.
--- Richard Erlacher <edick(a)idcomm.com> wrote:
I've got three of their FA310 adapters and a
4-port FE104 hub for my 100BTx
segment. It's cheap, though there are cheaper ones, and the adapters work
at both 10 and 100 Mb rates. The hub does not handle both speeds, though...
...I've been satisfied with this hardware...
If you can justify it, a switching hub, capable of full duplex would perhaps
be nicer, since you then don't have to string two hubs where one will do.
I have other brands of NICs but a 100% NetGear infrastructure... an EN108,
8-port 10BaseT hub with 10Base2/AUI port on the back (only one works at a
time); an FE104, 100BaseT hub (currently not in use); and an FS108, 10/100
switch. *That's* the one you want. It should be available for under $200.
It supports full duplex either by negotiation (for newer stuff) or by force
via configuration switches (for older stuff). All of this stuff is tiny
with external wall warts. I like their stuff a lot.
If you don't want a big 10/100 switch, there is also a FS102 and FS104, two
and four port switch, respectively. I recommend switches over autosensing
hubs. They tend to pack more buffer RAM and allow independent collision
domains, permitting better network utilization under higher loads.
-ethan
=====
Infinet has been sold. The domain is going away in February.
Please send all replies to
erd(a)iname.com
__________________________________________________
Do You Yahoo!?
Bid and sell for free at http://auctions.yahoo.com