30 Jan
2005
30 Jan
'05
11:35 a.m.
On Sun, 30 Jan 2005, Al Kossow wrote:
Right. That was other thing that I was going to ask about. Is there a
way to tell the COPY command to not fail on errors? Is there a better
command than COPY to use to move files over?
Works very
nicely
Assuming there are no bad blocks on the floppy A Catweazel board in a PC will read DEC double density
discs as well
although I've not been very impressed with abilities of the data
separator code on double-density data.
I checked out the Catweazel recently and it's turned into much more than a
disk controller. That's not a bad thing, but at any rate, is the
software/drivers any good?
I've had the best results recovering RX02 data
using dual-wide QBus
floppy controllers that have a 50 pin interface (Sigma Designs et. al.)
and a Qume DT-8 drive.
I run RT11 on a ZIP drive, read a bunch of images, and sneakernet the
ZIP cart over to a system with E11 to dump the images.
Can you provide a few more details? I assume the ZIP drive is running off
a SCSI interface? How do you make the RX02 images under RT11: what
utility do you use?
I'm assuming since I can't find anything about subdirectories on RT11 that
they don't exist?
--
Sellam Ismail Vintage Computer Festival
------------------------------------------------------------------------------
International Man of Intrigue and Danger http://www.vintage.org
[ Old computing resources for business || Buy/Sell/Trade Vintage Computers ]
[ and academia at www.VintageTech.com || at http://marketplace.vintage.org ]