5 Feb
2002
5 Feb
'02
9:14 a.m.
I just checked mine...the battery is labeled as follows:
Panasonic Rechargable Battery
LCR6V4PL
6V 4ah/20hr
constant voltage chargew
cycle usage: 7.3~7.5V
stdby 6.8~6.9V
initial current < 1.6A
Good luck with your g40...btw, the g40 runs hpux 10.20 just fine
(ours initially ran hpux 9.0)...it will also run the latest and
greatest from hp (hpux 11i...though only in 32bit mode...not the full
64bit mode).
Enjoy!
-Bob
bbrown(a)harper.cc.il.us #### #### Bob Brown - KB9LFR
Harper Community College ## ## ## Systems Administrator
Palatine IL USA #### #### Saved by grace
-----Original
Message-----
From: Bob Brown [mailto:bbrown@harper.cc.il.us]
Physically, where is the case was the battery?
I have a G40 downstairs in our datacenter.
Take the front plate off -- you'll need a torx bit. (Also note
that the faceplate slides straight up, then straight out. You
might damage something if you're really adamant about pulling
it off sideways, or straight out before you lift up on it.)
Each power supply has two screws holding it in (torx again).
You'll also need to remove the drive cage above the PSU before
you pull the power supply out. (two more torx screws, near the
top of the cage) I think they're probably both the same, so
only one should need removed.
Once you get a PSU out (you shouldn't even need to pull it out
all the way...), look right in the front of the PSU, to the
right. I think that's the battery compartment. Mine is just
empty with a two-prong plug that I assume should plug into the
battery.
Chris
Christopher Smith, Perl Developer
Amdocs - Champaign, IL
/usr/bin/perl -e '
print((~"\x95\xc4\xe3"^"Just Another Perl
Hacker.")."\x08!\n");
'