DEC quad board rack

That's pretty neat. Nicely done. Marc On Dec 31, 2017, at 6:32 AM, Noel Chiappa via cctalk <cctalk at classiccmp.org> wrote: So, I've been making wooden racks to hold a lot of my DEC boards, and I've finally come up with a nice design for one, which holds quad boards: http://ana-3.lcs.mit.edu/~jnc/tech/jpg/QuadRack.jpg which holds them vertically. It's much better than the dual rack next to it, which holds them horizontally, which has the issue that the distance between the sides needs to be absolutely perfect, otherwise the boards tend to drop out of their slots. With the boards held vertically, it's much less sensitive. If anyone's interested in building one, I can whip up a drawing. (Note that the slots are offset slightly to the left because one needs different clearances for the solder and component sides.) The one shown uses 3 pieces of 1"x8"x6' (not sure what that translates to in that new-fangled French stuff :-). It would be tricky to make without a radial-arm saw, though - although I suppose a router with a small bit could be used, albeit tedious. Noel