13 Apr
2006
13 Apr
'06
4:19 a.m.
One thing is sure: you need the alignment pack to align the RK05.
BTW Brad, I will check what boards of RL drives I have. I can't
remember if they were from RL01 or RL02 drives, and if the boards
are OK. Better have a dead board than none. A dead one can be
repaired. No board is, well ... nothing.
- Henk.
-----Original Message-----
From: cctalk-bounces at classiccmp.org
[mailto:cctalk-bounces at classiccmp.org] On Behalf Of Brad Parker
Sent: donderdag 13 april 2006 13:04
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: RL drive lubrication
J Blaser wrote:
This message and attachment(s) are intended solely for the use of the addressee and may
contain information that is privileged, confidential or otherwise exempt from disclosure
under applicable law.
If you are not the intended recipient or agent thereof responsible for delivering this
message to the intended recipient, you are hereby notified that any dissemination,
distribution, or copying of this communication is strictly prohibited.
If you have received this communication in error, please notify the sender immediately by
telephone and with a "reply" message.
Thank you for your cooperation.
I opened each drive up, and did two things to each: 1) With
the upper and lower head 'trays' propped apart, I manually
exercised the r/w head carriage, moving it back and forth a
number of times, and 2) I put a couple of drops of oil on the
top of each motor's shaft, which was easily reached with the
service cover off.
I'm curious if anyone has done something similar with an RK05.
Certainly the bearings can be replaced, but can they also be
cleaned and relubricated? is it safe to pull the entire
voice coil assembly apart, clean the bearings and tracks,
relubricate and reassemble?
any suggestions? thx.
-brad