24 Jun
2002
24 Jun
'02
8:03 a.m.
Hi Rich
If this is the one I think it is, there should also be
some RAM on the board as well. It should work with a
KIM/SYM/AIM. I have one that I've used with my AIM.
The software is simple. You just write to the address
window for the EPROM a number of times and the EPROM
gets programmed. As I recall, the board can be configued
to do 2716's or 2732's. Poking around in your monitor
can find the memory locations.
Dwight
From: "Cini, Richard"
<RCini(a)congressfinancial.com>
Hello, all:
While cleaning up in the shop this weekend, I found what looks to be
an EPROM programmer board. It's manufactured by Digital Matrix Associates
with a part number of 6500-001-PWB.
It's about the size of a STD BUS card (4.5" x 6") with a 22/44 pin
edge connector and a right-angle 22/44 socket right above it. It has one ZIF
socket and 4 empty sockets. Forgot to count the pins, though.
It's either for an AIM65 or a KIM, but since I never labeled it when
I got it, I can't remember. I'm guessing the AIM65, thought.
Does anyone have any info on this card?
Rich
==========================
Richard A. Cini, Jr.
Congress Financial Corporation
1133 Avenue of the Americas
30th Floor
New York, NY 10036
(212) 545-4402
(212) 840-6259 (facsimile)
_______________________________________________
cctech mailing list
cctech(a)classiccmp.org
http://www.classiccmp.org/mailman/listinfo/cctech