28 Dec
2013
28 Dec
'13
6:50 a.m.
On Fri, 27 Dec 2013, Josh Dersch wrote:
On 12/27/2013 8:46 PM, Cory Smelosky wrote:
11/23 with a 1M memory board. Which should be >128K so long as nothing
went wrong.
I have a DLV11-J...I THINK one of those can be used as a TU58...but I
don't have a bootstrap module (yet) so I'm stuck with ODT.
I'm running at 4800 baud and I can go no higher or lower due to the lack
of wirewrap tools.
I had ot loading executables earlier...but then it stopped working. I'll
let it sit overnight and pick it back up tomorrow.
Evening...
I'm fighting with trying to get my disk formatted so I can use my PDP-11s.
;)
Tape records are:
0 zrqch0
1 zrqah0
2 zrqch0
3 zrqah0
Opening port /dev/ttyUSB0 .... Port open
?
Opened zrqch0 read-write
rrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrr
And it stalls after that many R and goes no further. I have no
alternative means to boot XXDP on this system...my only option is vtserver
until I get a drive formatted.
What hardware do you have in the -11 system? I seem to recall that vtserver
requires 128K to function properly. (Also -- I don't suppose you have a
second SLU, which would allow booting from emulated TU58...) What baud rate
are you running this at? I've had a bit of trouble here and there with USB
serial ports, you might try a different baud rate, start with something
slow...
- Josh
--
Cory Smelosky
http://gewt.net Personal stuff
http://gimme-sympathy.org Projects