Front panels

On Mon, Nov 2, 2015 at 1:28 PM, rod <rodsmallwood52 at btinternet.com> wrote: I think that should be 'CU'; Control Unit (CPU). First row is instruction decoder; second row is the instruction buffer; third row is the PC and instruction sequencer state; fourth row is a bunch of internal state bits. Fifth row is the computed address (the current state of the incredibly complex 6180 indirect addressing model). OU 1 ROW Operation unit; fixed point and boolean math. > DU 2 ROWS Decimal Unit. Does decimal math. APU 1 ROW Append Unit. Does virtual address translation. Towards the top are the "DATA" and "ADDRESS" panels which allow displaying and toggling in data. In addition the DATA switches are readable from by the software; Multics requires certain magic settings on the data switches, probably indicated by the bits of white tape in the picture. Also, the INITIALIZE button that does just that. The upper half of the display panel has the "Execute" button which causes a CPU fault based on the ADDRESS switches; Multics uses this to break out of wedged operation and reenter Bootload Command Environment (GRUB), where the operator can dump memory to a disk partition for analysis and reboot. Below the EXECUTE is the indicator register display; things like "negative", "carry", "zero" and the like. To the right of that is the history register display; the last 16 or 64 instructions and their operand values are kept in a circular queue; very handy for low-level debugging. Below that is ICT and FUNCTION REGISTER tracks communication between the units. I don't see the A and Q register display; they must be on the other panel. They have a distinctive 'crawl pattern' when Multics is idling. (You can see it in the youtube clip.) You may notice that there is no RUN/STOP switch. The 6180 runs all of the time. When it is first turned on, memory is zero and the PC is zero. Instruction code 0 is illegal, which causes a fault. It then executes the illegal operation fault handling word pair, which are zeros, and cause a fault while processing a fault: a Double Fault. It toddles off and executes the double fault handling word pair, causing a double fault. Somewhere on that display panel is the fault code display, which would show a steady double fault code. The BOOT button (sorry, not IPL here) is on the Input/Output Manager cabinet, not the CPU. It reads a tape record into low memory overwriting the interrupt handler word pair, and interrupts the CPU, which executes the interrupt word pair which now contains instructions to jump into the code read in from tape. There are some interesting gyrations to make the first tape record both a boot loader and a legitimate tape label. Anyway, I know what most of those lights mean. Initially, I am just going to build a plexiglass board and use LEDs, laid out in a similar order to the display; I'm mostly interested in CPU state. That will give me a better idea of the scope of the project, and allow me to make more educated decisions about the Mk. II display. A lot of helpful ideas from cctalk; thank you all very much. -- Charles