11 Dec
1998
11 Dec
'98
10:41 a.m.
I have a nice homebrew C1 superboard setup, with wooden sides and a sheet
metal case. User has added a "break" switch, baud rate toggle switch,
1Mhz/2Mhz switch, some other doodads. That's what the OSI machines were all
about :) I've also got a manual or two lying around.
Also I have a bareboard superboard which has had all chips removed, so it's
obviously dead dead.
My friend has an original, almost pristine, C1P disk system which he'll
never part with. He has lots of software, too.
I know of a C1P system, boxed, for sale at around US$1000 - out of my
league, I'm afraid.
A
-----Original Message-----
From: CLASSICCMP-owner(a)u.washington.edu
[mailto:CLASSICCMP-owner@u.washington.edu]On Behalf Of SUPRDAVE(a)aol.com
Sent: Saturday, December 12, 1998 9:07 AM
To: Discussion re-collecting of classic computers
Subject: Re: Annual troll for Ohio Scientific
I have a C1P with a complete set of documentation and presale material
including schematics. i believe i also have a bare disk
controller board, but
i dont know for sure. i might need some of my parts identified.
david
In a message dated 12/11/98 11:15:06 AM Pacific Standard Time,
george(a)racsys.rt.rain.com writes:
<< It has been at least 6 months so maybe it is time again.
I'm always looking for OSI hardware. I am specifically looking
for C4 and
C8 machines and/or Floppy drives for such critters.
Perhaps we could create an inventory list among us and see if we might be
able to mix/match to build more complete systems.
I'll start:
I have the following:
C2-4p Empty case
C4p Comes up with 256 Bytes of RAM >>