15 Jun
2015
15 Jun
'15
9:06 a.m.
On Jun 15, 2015, at 09:02, Guy Sotomayor <ggs at
shiresoft.com> wrote:
I'm not specifically familiar with the 11/730, but what's wrong with just cabling
up an expansion box "the old fashioned way" using BC11A cable?
Without losing anything else in the already-full rack, I'd need to route that cable
between two racks. It's already tricky to roll the cabinets back into place without
rolling over the existing round snakes between the cabinets, and I figure that wide ribbon
cables would be more cumbersome (or is the BC11A round?). I have the system in a tiny room
where it's not practical to have space behind the racks to get rear access without
rolling them.
--
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/