18 Aug
2016
18 Aug
'16
4:25 p.m.
On Aug 17, 2016, at 10:37 PM, Douglas Taylor <dj.taylor4 at comcast.net> wrote:
I've brought up a MicroVax II and installed VMS 5.5-2 on a SCSI2SD disk and it is fun
to work with. (I also installed openvms 7.2 without much drama)
The problem I am having is that is has a TK50 tape drive and controller, but it never has
shown up in the device list. I even swapped in a different controller.
The DHV11 did show up initially but has now disappeared from the device list. Did I do
this by removing boards and putting them back in?
A RQDX2 board was put back in at a secondary CSR address and that shows up (it is
connected to an RX50 which shows up in the device list).
Does Autogen recognize new hardware?
If you are not familiar with the BA23 or BA123 enclosures, make sure you aren?t plugging
the controllers in the PMI slots.
This would be 1-3 CD on the BA23 and 1-4 CD on the BA213. Things will be very unhappy if
you accidentally do this.
see http://decvax.50megs.com/doc/qbus/tutorial.html
<http://decvax.50megs.com/doc/qbus/tutorial.html>
Jerry