29 Jul
2015
29 Jul
'15
7:05 a.m.
On 29/07/2015 14:11, Vincent Slyngstad wrote:
From: Pete Turnbull: Wednesday, July 29, 2015 2:57 AM
> Firstly, to add a small fillet to the junction of post and flat
Are you referring to the junction of the post and the
block? That would
be easy enough to do (though tedious in SketchUp).
Yes, that's where I meant.
Or are you referring to the bottom edges of the slots?
No, that shouldn't matter since it's in slight compression.
One concern that I had was that the new design might
end up trying to
ovalize the (brittle) socket in the mating panel, since the new posts
are only really compressible in one axis.
I doubt that matters much either, because it's the posts that break, not
the sockets.
--
Pete
Pete Turnbull