MIL-MOD8 (8008) simulator and a few other goodies posted

Over the break I finally got around to writing a simulator for the Microsystems International Limited MOD-8 (Modular-8). It has been very educational and interesting, and the final result of being able to experience what is like to run a very early microprocessor (8008) based system from Canada has been well worth it. The simulator is available on my site in the MOD8 section (Under "Designed in Canada") - I have also included an 8008 assembler, and my retyped source code to the MOD-8's ROM monitor (Monitor-8). This is the first step in getting my MOD-8 system up and running. I have a complete chassis (MOD8-8), as well as unpopulated ROM (MOD8-4) and RAM (MOD8-5) cards. What I don't currently have is the CPU (MOD8-1), Restart/TTY I/O (MOD8-2) and Control Buffer (MOD8-3) cards. If anyone can help locate these cards, it would be greatly appreciated. I do have several vectorboards which match the MOD-8 card format, and I will eventually construct the boards that I am unable to locate, however I would like to restore the system to as nearly original as possible. I will also need to locate a few more 1702 EPROMs - I have 3-4 of them, but the system needs a minimum of 7 for the ROM monitor. Programming them will also be a challenge (even my trusty DIO 29B doesn't do 1702s and the requirement for -40v as logic-low makes for a more complex construction project than I would like considering I will probably never need it again) - but the MOD8 has a built in 1702 programmer - Currently, I am planning to make a ROM board with a 2716 on it once I have the rest of the system completed, and use it to program 1702s for the original ROM board - an interesting kind of hardware/software bootstrap. The MOD8 was also known as the "GNC8" (Great Northern Computers), and a later version used an 8080 processor (MOD80). Any other MOD8/GNC8/MOD80 owners or interested parties out there? ----- Other things posted to the site over the break: - Updated my paper tape tools with PTE, a Paper Tape (reader) Emulator - allows you to send the content of the paper tape images over a serial or parallel interface as if from a physical reader. - Updated the NST (North Star Transfer) utility in my Horizon package to include a "Clean Head" function - easier than using N*DOS "RD" command to sweep the head back and forth over a cleaning disk. - Added disk images to the archive for: NorthStar Advantage (thanks Joachim!) Coleco Adam Regards, Dave -- dave06a (at) Dave Dunfield dunfield (dot) Firmware development services & tools: www.dunfield.com com Collector of vintage computing equipment: http://www.classiccmp.org/dunfield/index.html