10 Jun
2015
10 Jun
'15
12:47 a.m.
Mark,
Traditional 9-track tapes are always written block-by block with a "short"
gap between the records, WikiPedia say 0.6" for 1600BPI which sounds about
right. From what I remember as tapes are not the most reliable medium the
process was to have the read head after the write head so the tape could be
read and checked as it was written. If an error was returned the "system"
would backspace, erase the bad block to create a "long gap" and the try
again. Looking at the first MAN page for TAR I found it says it writes
20x512 byte blocks so 10K blocks, i.e. about 6.4" long. That means a
"waste"
of 10% of the tape in gaps, assuming the tape is perfect. You can write
longer blocks but then the amount of wastage when you write a bad block goes
up.
So I guess to answer your question. Operating systems and tools expect a
block level interface to tapes. You need to duplicate this in your
interface.
Dave
-----Original Message-----
From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Mark J.
Blair
Sent: 10 June 2015 08:34
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Pertec Tape Drive Interface Musings
I was looking at a couple of documents describing the Pertec tape
interface;
the manual for my Kennedy 9610 tape drive, and a nice
reference by a
fellow
with a rather familiar name:
http://www.sydex.com/pertec.html
According to my Kennedy manual, issuing a read command causes the drive
to return one block of data. I can see how that would be used in block-
oriented applications in which blocks may be randomly read, written and
re-
written on the tape. But most of my magtape experience
has been using the
tapes in a streaming mode, such as when reading/writing one or more tar
archives separated by file marks.
When writing a tar archive on a magtape from a Unix system, is the archive
written as a sequence of fixed-size blocks? Or is the entire tar archive
effectively written as one continuous block which must be streamed with no
repositioning?
I'm curious because I'm daydreaming about how to build a tape drive
interface controller, and I wonder whether it might need to potentially
stream an entire tape in one go vs. being able to safely assume some
maximal block size.
--
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/