24 Aug
2012
24 Aug
'12
8:19 a.m.
mc68010 wrote:
On 8/23/2012 6:07 PM, Eric Smith wrote:
The Z8 is not Z80 [not the same Arch or instruction set] and is a smaller
chip design as a single chip microcontroller. CP/M is not a fit for that.
Ez80 is close enough though.
microcode at zoho.com wrote:
Are there any versions of cp/m for any of the Zilog Z8 evaluation
boards like this
http://www.mouser.com/ProductDetail/ZiLOG/Z8F04A28100KITG/?qs=%2fha2pyFaduh…
Are there any modern ready-to-go SBCs capable of
running CP/M?
David Griffith wrote:
There was the P112, which I distributed until I ran out. If I can
get together a couple thousand dollars, I can kickstart a new run of
them. See http://661.org/p112/
Maybe it would actually make a good Kickstarter project?
They sell for less than $50. Seems much easier than
designing one off
home made z80 boards.
UR kiddin? All that is needed is Z80, 32-64K ram, some rom to boot,
some mass-storage, and a userIO [serial or parallel port to a terminal].
Allison