30 Mar
2007
30 Mar
'07
7:43 a.m.
Jay wrote....
I got +5v & GND for my logic probe from CA2 & CC2 and powered
up just the BA11K. BF1 & BF2 both showed low as I'd expect
(since the cpu was powered off). This was a sanity check on
my part to make sure AC/DCLO were pulled low. I powered up
everything and BF1 & BF2 went hi. I hit load on the RL02 and
the drive started to spin up. At just the time I'd expect the
heads to load, the fault lite came on. BF1 & 2 were still hi.
If the RX02 is powered off, the drive will not fault, it will
spin up fine. Also, if the RX02 is off and everything else
on, the drive loads fine and boots RT11. The moment I plug in
the power for the RX02 the RL02 immediately faults (but the
cpu keeps on running right where it was). One thing I need to
check, I am not positive (because it's all rather loud) that
when the RL02 faults that it spins down the drive. I don't
recall hearing the noticeable decrease in volume. I would
have thought it would spin down upon any fault. Maybe it is
and i just didn't hear it.
I can start going through the prints on the RL02 as Tony
suggested, looking at all the signals that can trip the fault
light. Is that the right approach? I mean, the problem
obviously isn't in the RL02 or controller - as they work
flawlessly if the RX02 is turned off. This would make me
think the problem is more likely something about the RL02 or M8256.
At least I'm learning a lot :)
Jay
Ooh, you're not the only one who is learning :-)
ACLO and DCLO are for me also signals to check. Tony pointed me
out that DCLO might be asserted by a (defective) memory board that
fails to initialize ... it was indeed that board that kepy my 11/84
from starting!
You can work your way back from the signal that drives the FAULT
lamp on the RL02. Perhaps an other approach is to check what signals
go from the RX02 drive to the M8256 RX211 controller. Especially,
where the signals from that flatcable go on the RX211 module, and
what effect they might have on the UNIBUS. Perhaps there is a short
in the flatcable between the RX02 and the RX211 that acts up when
the RX02 is powered?
good hunting,
- Henk.
This message and attachment(s) are intended solely for use by the addressee and may
contain information that is privileged, confidential or otherwise exempt from disclosure
under applicable law.
If you are not the intended recipient or agent thereof responsible for delivering this
message to the intended recipient, you are hereby notified that any dissemination,
distribution or copying of this communication is strictly prohibited.
If you have received this communication in error, please notify the sender immediately by
telephone and with a 'reply' message.
Thank you for your co-operation.